ESTIMATED TIME TO INSTALL 

• 20-30 MINUTES

TOOLS REQUIRED 

• WIRE CUTTERS
• RUBBING ALCOHOL
• RAG OR PAPER TOWELS
• PRY TOOL OR FLAT-HEAD SCREWDRIVER

DOWNLOAD

INSTALLATION GUIDE

1. Remove the scuff plate from the front passenger side by firmly pulling upwards.

2. Remove the retaining nut or hardware from the kick panel and pull the panel straight back.

3. Remove the plastic retaining clip and re-install it on the kick panel.

4. Plug the 8ft extension wire into the passenger side bar light. Route the wire next to the factory wiring. Zip-tie the wire loosely for now.

5. Continue routing the wire down the sill plate channel.

6. Move the passenger seat to the forward position.

7. Route the wire under the carpet fold.

8. Route and tuck wiring through the elastic straps on each corner under the seat.

9. Plug in the passenger side bar light. Clean both surfaces, apply 3M tape for leather seats or velcro for cloth, and mount the bar light.

10. Tuck the wire under the carpet and route under the
seat rail. 

11. Start routing and tucking the wire along the center console and over towards the driver seat.

12. Route the wire under the carpet.

13. Bring the wire up next to the factory wiring harness and tape or zip tie to the harness.

14. Tuck the wire under the elastic, as shown in step 8. Clean the under-seat surface and mount the second light bar.

15. Confirm both seats move in the full range of motion without pulling the wires. Zip tie or tape any loose wiring. Enjoy your new rear footwell lights!