ESTIMATED TIME TO INSTALL 

• 10-15 MINUTES

TOOLS REQUIRED 

• Isopropyl Alcohol
• Wire Cutters

DOWNLOAD

INSTALLATION GUIDE

1. Remove the factory high beam bulbs on the inner portion of the headlight.

2. Unclip the factory harness from the bulb and set aside.

3. Install 9005 Monochrome bulb into housing.

4. Secure controller with provided zip ties or tape.

5. Remove black vinyl cap from the smooth black wire exiting the control box. It should not require much force to remove the cap.

6. Attach VLR 15 load resistor to the 2 pin plug.

7. Attach VLR tape to backside of resistor and remove red backing.

8. Find an area in the engine bay that is metal and away from plastic or wires as the resistors will generate heat. Clean surface with isopropyl alcohol or similar solvent and adhere to metal surface. During cold temperatures surface may require heating so tape sticks well.

9. Connect Monochrome 9005 plug to factory harness. Repeat for the other side.

10. Installation complete! Enjoy your new DRLs and high beams!